Step 1
Starting with the Oval
Draw in an oval. Be careful to measure the proportion of how tall the head is to how wide using a pencil held in your hand and extended at arms length use the tip of the pencil and your thumb to take proportional measurements. I forgot to do this and instead jumped right into the drawing and I had to go back and do some major revisions to my drawing that could have been avoided if I had taken more care.
Step 2
Measure off the Eye, Nose and Mouth Lines
Establish a center line, 1/2 of the Oval for the eye line, 1/4 nose line and 1/8 mouth line. From there look for the small variances in the person’s features. Measure the features, everyone’s eyes, nose and mouth will vary being slightly longer or shorter than the standard proportions (example the nose is usually half way between the eyes and chin. Some people will have a nose slightly longer or shorter.)
Try to get as close as possible to that person’s unique proportions. Use your pencil and thumb to gauge accurate proportional measurements. After measuring the head I moved the chin line a little lower. I also reestablished the width of the head after observing the width of her head was about the same as the length from the bottom of her chin to her eyebrow. I then marked the eyebrow line. I then measured and marked where the forehead ended. The distance from brow to forehead was the same as from the chin to nose.
Check the following relationships and measure them (remember these are proportional measurements. Using pencil and thumb.)
1. Eyes to the Chin
2. Eyes to the Top of the Head
3. Nose to eyes
4. Nose to chin
5. Head width across the eye line to chin to brow
6. Compare brow to hairline against nose to chin.
Mark off all the relationships you note while comparing these areas.
Step 3
Drawing in the Features Using Basic Shapes
I begin to draw in the basic eyes, nose, mouth and eyebrows ( I will do detailed art tips on drawing the individual features later.) These basic shapes allow me to observe the basic relationships between the features and allows me to see what I may have missed and what needs to change.
Step 4 Modify and Refine
After all the remeasuring I saw a couple of needed changes. I noticed I made the head too long, her head needed to be a bit wider. The eyes were slightly too close together especially after widening the head so I moved the eyes(this is why I kept the features simple so changes would be much easier to make.) I redrew the nose, changed the mouth slightly, and redefined the shape of the hair as it defines the forehead. Below shows me in the process of making the changes I have listed.
Step 5
Recheck and Refine
After getting everything redrawn I noticed I still had the face too long so I modified the width by about a 1/16th of an inch. I widened the space between the eyes by about 1/32nd of an inch. I redrew the lips widening them about 1/16th of an inch and finally widened the nose just under 1/8th of an inch. These little changes really helped. Look at the final sketch below.
